You should be able to create a tunnel pointing to the wan1 secondary IP. You should be able to create a tunnel pointing to the wan1 IP.ģ) You set a secondary IP address on the wan1 interface and set this address as a local-gw also under the IPSec configuration.
#IVPN PUBLIC IP ADDRESS NOT WORKING HOW TO#
Disconnect from the VPN and follow the steps in How to reset your DNS settings. You should be able to create a tunnel pointing to the wan1 IP.Ģ) You leave your wan1 IP address settings as you have and you set the local-gw to the IP address of your wan1 IP under the IPSec configuration. Resolving DNS Issues The first step is to reset your DNS settings. In this case, traffic to that IP would never reach your router. Most ISPs do their own NAT now, where multiple users will share the same public IP, but may assign you one if you ask (or pay). There are some possible solutions according to me:ġ) You leave your wan1 IP address settings as you have (I assume that the firewall is reachable on this address) and you set the local-gw to 0.0.0.0 under the IPSec configuration. Hi guys, I have noticed when I go to whatsmy.i.p.com, my real i.p. 41 1 6 Check that your ISP is actually assigning you a static public IP. One IP from this address block will be providers PE (your gateway) so you have 5 public static IP for use.ĭo not forget to set a default route to the gateway. If you have 6 IP addresses to use probably your address range is x.x.236.16/29 (255.255.255.248) where you can use addresses from x.x.236.17 to. It cannot be an internet point-to-point address, it has to be at least 255.255.255.252 (/30).
According to your description of the problem it seems to me that the problem is with the IP addresses.įirst of all your wan1 address has a mask 255.255.255.255 (/32).
0 kommentar(er)
